Resistor measure with pwm and adc?


+ Reply to Thread
Results 1 to 7 of 7

Thread: Resistor measure with pwm and adc?573 days old

  1. #1
    Junior Member Maxi's Avatar
    Join Date
    Mar 2010
    Posts
    93
    Thumbs Up
    Received: 1
    Given: 25
    Total Downloaded
    5.30 GB

    0 Not allowed!

    Default Resistor measure with pwm and adc?

    Sometime, when I reading magazine project
    I can see people reading low values resistor with pwm and microcontroller (like 10 ohm, 100 ohm etc)
    how can we make it?

Attention

This valuable resource relies upon the very small amount of revenue generated by displaying online advertisements to our visitors.

The advertisements we display are relevant to this web site and your browsing history

Please consider supporting us by disabling your ad blocker.


Note: Some users have reported issues related to ad-blockers rendering parts of this wesite unusable,
where possible we will rectify the issues to enable you to use this resource with adblocking enabled.

If you can, please report issues in the forum area WebSite / Forum Issues


Thank you for your attention.

  • #2
    Fanatical Contributor Tim's Avatar
    Join Date
    Jan 2003
    Posts
    7,689
    Thumbs Up
    Received: 47
    Given: 95
    Total Downloaded
    1.32 GB

    0 Not allowed!

    Default Re: Resistor measure with pwm and adc?

    You can just use the ADC in an resistor divider set up.
    Tim

  • Attention

    This valuable resource relies upon the very small amount of revenue generated by displaying online advertisements to our visitors.

    The advertisements we display are relevant to this web site and your browsing history

    Please consider supporting us by disabling your ad blocker.


    Note: Some users have reported issues related to ad-blockers rendering parts of this wesite unusable,
    where possible we will rectify the issues to enable you to use this resource with adblocking enabled.

    If you can, please report issues in the forum area WebSite / Forum Issues


    Thank you for your attention.

  • #3
    Junior Member Maxi's Avatar
    Join Date
    Mar 2010
    Posts
    93
    Thumbs Up
    Received: 1
    Given: 25
    Total Downloaded
    5.30 GB

    0 Not allowed!

    Default Re: Resistor measure with pwm and adc?

    no thanks, I can measure with divider already
    but I want to learn use with pwm+adc
    someone know that

  • Attention

    This valuable resource relies upon the very small amount of revenue generated by displaying online advertisements to our visitors.

    The advertisements we display are relevant to this web site and your browsing history

    Please consider supporting us by disabling your ad blocker.


    Note: Some users have reported issues related to ad-blockers rendering parts of this wesite unusable,
    where possible we will rectify the issues to enable you to use this resource with adblocking enabled.

    If you can, please report issues in the forum area WebSite / Forum Issues


    Thank you for your attention.

  • #4
    Senior Member Henk57's Avatar
    Join Date
    Jan 2014
    Posts
    406
    Thumbs Up
    Received: 19
    Given: 35
    Total Downloaded
    192.60 MB

    0 Not allowed!

    Default Re: Resistor measure with pwm and adc?

    Quote Originally Posted by Maxi View Post
    ....someone know that
    Not me!

    Henk.

  • Attention

    This valuable resource relies upon the very small amount of revenue generated by displaying online advertisements to our visitors.

    The advertisements we display are relevant to this web site and your browsing history

    Please consider supporting us by disabling your ad blocker.


    Note: Some users have reported issues related to ad-blockers rendering parts of this wesite unusable,
    where possible we will rectify the issues to enable you to use this resource with adblocking enabled.

    If you can, please report issues in the forum area WebSite / Forum Issues


    Thank you for your attention.

  • #5
    Senior Member Stephen Moss's Avatar
    Join Date
    Jan 2006
    Posts
    523
    Thumbs Up
    Received: 31
    Given: 7
    Total Downloaded
    3.87 GB

    0 Not allowed!

    Default Re: Resistor measure with pwm and adc?

    Are you certain that is what they are doing?

    I would think that a capacitor has to be involved somewhere to crate an average voltage for the ADC to read, I assume you could not see a capacitor being used to average the voltage so they may somehow be utilising the inherent capacitance of the in I/O pin or ADC input stage to create the averaging.

    In which case if the I/O pin capacitance is being used I would think that would probably only work at a very specific modulation frequency, modulation depth and for a small range of resistors. If the ADC capacitance is being used then perhaps the PWM modulation depth is being varied until a specific voltage is read on the ADC and it is the modulation depth rather then the input voltage read by the ADC that corresponds to the resistor value.

    However, this is just speculation as we have been given virtually no information go on, perhaps if a copy of a relevant article(s) was supplied it would be easier for someone to deduce the method being used from the circuits operating description/diagram.

  • Attention

    This valuable resource relies upon the very small amount of revenue generated by displaying online advertisements to our visitors.

    The advertisements we display are relevant to this web site and your browsing history

    Please consider supporting us by disabling your ad blocker.


    Note: Some users have reported issues related to ad-blockers rendering parts of this wesite unusable,
    where possible we will rectify the issues to enable you to use this resource with adblocking enabled.

    If you can, please report issues in the forum area WebSite / Forum Issues


    Thank you for your attention.

  • #6
    Junior Member Maxi's Avatar
    Join Date
    Mar 2010
    Posts
    93
    Thumbs Up
    Received: 1
    Given: 25
    Total Downloaded
    5.30 GB

    0 Not allowed!

    Default Re: Resistor measure with pwm and adc?

    you are right, Im looking a sample for what Im talking about

  • Attention

    This valuable resource relies upon the very small amount of revenue generated by displaying online advertisements to our visitors.

    The advertisements we display are relevant to this web site and your browsing history

    Please consider supporting us by disabling your ad blocker.


    Note: Some users have reported issues related to ad-blockers rendering parts of this wesite unusable,
    where possible we will rectify the issues to enable you to use this resource with adblocking enabled.

    If you can, please report issues in the forum area WebSite / Forum Issues


    Thank you for your attention.

  • #7
    Fanatical Contributor Tim's Avatar
    Join Date
    Jan 2003
    Posts
    7,689
    Thumbs Up
    Received: 47
    Given: 95
    Total Downloaded
    1.32 GB

    0 Not allowed!

    Default Re: Resistor measure with pwm and adc?

    You have not given us any information at all.

    Until you show a schematic or link to the article there is nothing people can do to help you.
    Tim

  • Attention

    This valuable resource relies upon the very small amount of revenue generated by displaying online advertisements to our visitors.

    The advertisements we display are relevant to this web site and your browsing history

    Please consider supporting us by disabling your ad blocker.


    Note: Some users have reported issues related to ad-blockers rendering parts of this wesite unusable,
    where possible we will rectify the issues to enable you to use this resource with adblocking enabled.

    If you can, please report issues in the forum area WebSite / Forum Issues


    Thank you for your attention.

    Thread Information

    Users Browsing this Thread

    There are currently 1 users browsing this thread. (0 members and 1 guests)

       

    Similar Threads

    1. Comparing two voltage levals fron 2 ADC chanels for the decession of PWM duty
      By farrukhtalib in forum Absolute Beginners Section
      Replies: 2
      Last Post: 18th September 2015, 09:23
    2. [SOLVED !] PWM, dithered PWM and Tmr1 as a (variable bit) PWM source.
      By david in forum The Lounge
      Replies: 8
      Last Post: 2nd August 2013, 12:57
    3. Replies: 5
      Last Post: 30th March 2011, 07:06
    4. [SOLVED !] ADC pull down resistor
      By picprotonguy in forum The Lounge
      Replies: 5
      Last Post: 28th February 2009, 13:37
    5. Help on ADC to PWM
      By einet in forum Proton Plus Compiler v3
      Replies: 9
      Last Post: 26th August 2007, 18:22

    Posting Permissions

    • You may not post new threads
    • You may not post replies
    • You may not post attachments
    • You may not edit your posts