By: AlbertoFS
Today 14:24
Forum: Proton Plus Compiler v3
Starter: SELCUK
Views: 0
Replies: 2
Hello,
What is the differance and usage for :
DIM myVar as BYTE ;// WORD, DWORD, FLOAT etc..
or
DIM myVar as BYTE SYSTEM ;// WORD, DWORD, FLOAT etc...
I use the system variables only for the libraries which allows faster access to them.
See these threads.
http://www.protonbasic.co.u k/showthread.php/65576-System-Variables post 5
http://www.protonbasic.co.u k/showthread.php/77204-System-variables
Regards
|
By: J. Mark Wolf
Today 12:18
Forum: Proton Plus Compiler v3
Starter: J. Mark Wolf
Views: 0
Replies: 7
I'm a long time registered user with an older compiler (v3.5.5.3) and even older USB key (11 years old). I haven't run my compiler in several years, and I seem to recall I needed a patch that I never installed. I tried this evening to revisit some old programs and none would compile, complaining it was "Unable to find PrPrc.exe - Make sure it's...
Update:
I was able to successfully upgrade my compiler by adding the Proton website to the compatibility settings in Internet Explorer, which automatically changed the .PHP extension to .EXE.
I then attempted to "run" the downloader, which failed. Downloading the file first then running it from my local drive worked.
Thanks for the...
|
By: crankshaft
Today 12:07
Forum: Proton Plus Compiler v3
Starter: crankshaft
Views: 0
Replies: 0
Has anyone been successful with this ?
I know that the FVRCON register needs to be set correctly to enable the built in sensor, and to set it's voltage range.
But the A/D Channel for the sensor is 0x1D - how can I read that through PDS as AD_VALUE = ADin $1D does not appear to work ??
Has anyone been successful with this ?
I know that the FVRCON register needs to be set correctly to enable the built in sensor, and to set it's voltage range.
But the A/D Channel for the sensor is 0x1D - how can I read that through PDS as AD_VALUE = ADin $1D does not appear to work ??
|
By: Stephen Moss
Today 10:22
Forum: Proton Plus Compiler v3
Starter: crankshaft
Views: 0
Replies: 1
Spent the last 2 days on this and are hoping someone can help, as I have googled and tried lots of things and there's not much in these forums related to I2C slave and particularly the 12F1840 which is an 8 pin device that I need to use.
This is the data sheet which I have been studying and using:...
I think you may need to look at your OSCON register settings, as you only list 6 bits I am not sure if they are the upper or lower 6, either way I think that would result in either a 2MHz or 125KHz clock.
I started looking at using the same device as a I2C slave for work but it is a low priority task so I did not really get beyond the device...
|
By: towlerg
Yesterday 18:15
Forum: Proton Plus Compiler v3
Starter: Dave-S
Views: 0
Replies: 5
Is there any way to select a choice of a include file, ie: by holding a button connected to a Pin?
I don't know of an example of a composite device using Proton. Essentially you need to merge the two descriptors.
How do you select layouts?
I don't see what the HID is doing.
| | | | | | | | |
UMC Loader Device.inc file info for 18f4331
Reply With Quote
