John Drew
Administrator

Hi John,
thank you for all your support. I have downloaded the latest Proton manual from May 2016. Has this file been updated as the dates are still 2014?
Also, do you know if the declare MemWrite_Int_Control is supported as its not in the manual. It s hould be implemented from 3.5.7.7.
Thanks.
Kai

I was trying to download the "Full install of version 3.5.8.0 of Proton and version 1.0.3.2 of Proton24" from the site using the link http://www.protonbasic.co.uk/vbdownl...ile&fileid=486 but I get a message saying "BillR, you do not have permission to access this page." any thoughts? I am logged in. Thanks John for your assistance.
Bill Rau

Thank you very much John,
I have a lot pending projects, I don't know where to go ...
Alberto

Will do. Had a busy day. Will create the SPI category and then publish the second one in there. It's too hard to create new categories on my little tablet so will get it fixed in the morning. Just got home from a meeting. It's 22:20 here in Oz. I did publish the first article, thanks, you're doing a terrific job as a contributor.
Best wishes
John

Hi John,
I wrote 2 articles to be published. Please see the Wiki-Discusion forum.
Alberto

Hi Alberto,
I'll get to it in the morning.
Best wishes
John

Hi John,
I am writing a new article for software SPI, could you insert a new folder "SPI" in the "Code Example" folder of the WIKI?
Thank you,
Alberto

Hi Alberto,
I've made a few small changes to the article to help it read a little better. I did look at your schematic and wondered why you used the 8 data lines. I find that 4 lines work fine and less messing around with connections and it leaves a few more ports available in case of later additions.
It's published as you have probably noticed.
Best wishes
John

Hi John,
I wrote a new article. Please see the wiki section. Thank you.
Alberto

Hi John,
I wrote a new library for xTEA encryption. See the WIKI discussion folder. I am tireless ...
Alberto