• PicŪ Basic


  • Alphanumeric LCD Issue

    Alphanumeric LCD acting weird until I used pull up resistors on input of unused D0-D3 pins.

    Other pins were connected direct to the micro. I was convinced that this erratic behaviour was a software bug, since I had used these displays before.

    I spent many hours trying different things and the answer was right in front of me. The problem was I figure these pins are not being used so I'll ground them to prevent random errors as I was taught to do in school. And this end up making the display act very temperamental. It ran better with d0-d3 unconnected and perfect with the pull up resistors.

    Long story short... humanware was at fault, not hardware, not software, not firmware.
  • Recent Activity

    normnet-324

    FineLineIDE

    Thread Starter: normnet

    Coming soon a new IDE: FineLineIDE! Features include:<O:p</O:p Bracket lines linking If-Endif, For-Next etc.<O:p</O:p Tabbed explorer so...

    normnet Yesterday, 09:31 Go to last post
    Henk57-24049

    Compiler 3.6.1.7 issue with 16F1829 and I2C-LCD

    Thread Starter: Henk57

    Spend this afternoon with a compiler issue; no error's, but my LCD give only first line with squares, no characters, nothing. If I flash an old .hex...

    Henk57 Today, 03:19 Go to last post
    normnet-324

    New dual core dsPIC33CH PIC

    Thread Starter: normnet

    The Master core and Slave core can operate independently, and can be programmed and debugged separately during the application development. Both...

    normnet Yesterday, 23:42 Go to last post