Proton BASIC Compiler - Using a 2 x 16 LCD Address Lines as


  • Pic® Basic


  • Using a 2 x 16 LCD Address Lines as Button Inputs

    Mark Rodgers G0EBB 20,01,03


    The above circuit uses a PIC16F877 but it will work with any PIC® you choose, the file that supports the hardware will need to be changed to suit the pins chosen for the address lines you use on your PIC®.
    This diagram must be used with LCD_KEY.BAS.

    How it works

    The connection of the LCD is as standard and this circuit and software can be very easily used in any existing project or new one. The buttons do not interfere with the operation of the display in any way.

    The four 10k resistors hold the address lines high and the 1k resistors are to limit the current in case of errors (i.e. two pins trying to pass current through the switch).
    The buttons could easily be any external signal that is normally open and does not carry any power of its own.

    The software is very simple and works as follows;

    1, Make RC1 (common line of switch) to an output and clear it (connect to 0 volts)
    2, Make RD4 an input, check if the button has been pressed (value=0) or if it has not been pressed (value=1), if pressed then give the variable KEY a value (1,2,3 or 4 etc).
    3, Repeat 2, above with RD5 etc.
    4, Make RC1 (common line of switch) an input and continue with the rest of your code.

    The use of control line RC1 is to stop a button press corrupting the display if it is pressed when the display is being sent data. I have never seen any corruption of the display using this system and it has proved 100% reliable.

    I use the software as a subroutine and call it just before I need a key input with the line “GOSUB button_check” and generally use the subroutine as an “include” file.

    I hope you find this useful.

    73 de Mark Rodgers G0EBB.

    Download the code HERE
  • Recent Activity

    keytapper-79800

    Negetive Numbers with minus sign

    Thread Starter: amod

    Hi, Iam making a load indicator with HX711.My Problem is with negetive numbers and minus sign.Iam using 4 digit seven segment display.fourth display...

    keytapper Today, 06:40 Go to last post
    keytapper-79800

    CWrite and ISR

    Thread Starter: joesaliba

    I am struggling to make work CWrite and Interrupt together. If I comment out: - On_Interrupt Isr ' Where to go on an Interrupt ...

    keytapper Today, 05:44 Go to last post
    towlerg-21522

    Sleep and how to use it

    Thread Starter: Tim

    Hi, I need to save power in a device (16f1823) so thought, sleep a lot. But I never really used the command before. Reading the data sheet I...

    towlerg Today, 14:16 Go to last post