• PicŪ Basic


  • TLP590B

    A Nifty Chip !

    The TOSHIBA TLP590B consists of an aluminum galium arsenide infrared emitting diode optically coupled to a series connected photodiode array in a six lead plastic DIP package.




    TLP590B is suitable for MOS FET gate driving.

    Suitable for driving a FET in a high side drive configuration, optically isolate and makes a good switch.
    It is not fast enough for switching control, but work excellent for DC motor bridge direction control.
    Timing can be about 5ms to be safe. Since the FET gets switched ON or OFF there is very little heat
    in the FET to worry about.

    Use a single TLP590B for driving a logic level FET, or two in series to drive standard FET's.
    The LED's can be driven in series for 5V PICŪ, in parallel for 3V3 PICŪ.



    A basic H-bridge that works. The motor voltage is limited by the FET's
    The switching is smooth and very little spikes and noise is generated.
  • Recent Activity

    Les-15

    Num_Byte on 18F26K42

    Thread Starter: towlerg

    I'm using a macro that was created by the generator Dump Macro P1 #if (Prm_Count > 1) #error "Dump - Too many parameters" #else ...

    Les Today, 17:17 Go to last post
    John Drew-26

    Fault in bit wise comparisons on release 3.6.1.2.

    Thread Starter: kbaykar

    Hi Les, I just downloaded the release 3.6.1.2 today and seeing that it supports 18F47K40. I am trying to port my code from 18F4685 to 18F47K40. ...

    John Drew Today, 13:41 Go to last post
    SimonJA-751

    Hx711 calibration

    Thread Starter: amod

    Iam using load cell amplifier HX711 module.I have got raw values from module but iam not able to calibrate with load cell.I want make a universal...

    SimonJA Today, 07:38 Go to last post