Proton BASIC Compiler - Interfacing to a DS1990 i-Button device


  • PicŪ Basic


  • Interfacing to a DS1990 i-Button device

    A DS1990 is an i-Button device that has a unique ID value imprinted within it. It can be used as an electronic key, or pass etc.. They're quite old devices, but are still extremely valid in modern times.















    The code below illustrates how to interface to a DS1990 one-wire i-Button device

    Code:
    '
    ' Read a DS1990 on-wire device
    '
       Device = 12F683
       Declare Xtal = 8
       Declare Optimiser_Level = 2
    
       Declare Serial_Baud = 9600
       Declare Rsout_Pin = GPIO.0
       Declare Rsout_Mode = 0
    
       Dim tDevicePresent As Bit       ' Holds 1 if the device is present, otherwise 0
       Dim ROM_NO[8] As Byte           ' Holds the read values from the device
    
       Symbol DQ_Pin = GPIO.1          ' Pin where the device is attached
    
    '--------------------------------------------------------------------------------------------
       GoTo Main                       ' Jump over the subroutines
    
    '--------------------------------------------------------------------------------------------
    ' Read a DS1990 one-wire device
    ' Input     : None
    ' Output    : tDevicePresent will contain 1 if a device is present
    ' Notes     : None
    '
    $define Device_Read() GoSub _Device_Read   
    
    _Device_Read:
      OWrite DQ_Pin, 1, _No_Device, [$33]
       ORead DQ_Pin, 0, [ROM_NO#0, ROM_NO#1, ROM_NO#2, ROM_NO#3, ROM_NO#4, ROM_NO#5, ROM_NO#6, ROM_NO#7]
       tDevicePresent = 1
       Return
    
    _No_Device:
        tDevicePresent = 0
        Return
    
    '---------------------------------------------------------------------------------------------------
    Main:
       Clear ANSEL                             ' \ Make pins digital
       CMCON0 = 7                              ' /
    
       While                                   ' Create an infinite loop
           Device_Read()                       ' Attempt to read the device
           If tDevicePresent = 1 Then          ' Is the device present?
               RSOut Dec ROM_NO#0, Dec ROM_NO#1, ",", Dec ROM_NO#2, ",",_
                     Dec ROM_NO#3, ",", Dec ROM_NO#4, ",", Dec ROM_NO#5, ",",_
                     Dec ROM_NO#6, ",", Dec ROM_NO#7, 13
           Else                                ' Otherwise... The device is not present. So....
               RSOut "No Device\r"             ' Transmit a message
           EndIf
           DelayMS 100
       Wend
    The video below shows the above program running within the proteus simulator:

  • Recent Activity

    Les-15

    I'm over the moon with joy. :-)

    Thread Starter: Les

    I just had to show you this, because I am over the moon with it. LOL I've just about finished procedures on the Proton 8-bit compiler so I am busy...

    Les Today, 15:17 Go to last post
    Mellbreak-21950

    Valid time in NMEA sentance

    Thread Starter: SimonJA

    Is there any way to know that a GPS nmea sentence has the correct time? I use a module to keep a pic rtc accurate but have noticed that when...

    Mellbreak Today, 15:54 Go to last post