Proton BASIC Compiler - PCB Rework Equipment


  • PicŪ Basic


  • PCB Rework Equipment RSS Feed

    Article Preview

    This is how you can make an easy Hot Plate. Put the soldering iron away, it is way too big for those little pins and besides, ...
    Article Preview

    A thermocouple is created when certain alloys are mechanically joined with another alloy, the result is a junction that ...
    Article Preview

    For many people using these fine pitched ICs is a problem since their pin pitch has become so small you can barely see the ...
    Article Preview

    There is no easier way to place components than to use vacuum. You need low volume and low vacuum.

    Vacuum ...

    This article is not ready yet. I'm trying to find an easy way to generate pressure to use for dispensing solder.
    ...
    Article Preview

    A recent forum discussion related to PCB cleaning, carried a few posts on the various fluids that might be used. Poeple often experiment with non standard substances in an effort to find cheaper or more efficient solutions to common day probelms. PCB's are often contaminated with hard to remove substances, anything from greasy finger marks to glue from labels.
    ...
    Categories:
    1. PICŪ BASIC
    Article Preview

    by Olivier de Broqueville



    Developing often small prototypes, and hating 'proto' ...

  • Recent Activity

    Les-15

    I'm over the moon with joy. :-)

    Thread Starter: Les

    I just had to show you this, because I am over the moon with it. LOL I've just about finished procedures on the Proton 8-bit compiler so I am busy...

    Les Today, 15:17 Go to last post
    towlerg-21522

    Valid time in NMEA sentance

    Thread Starter: SimonJA

    Is there any way to know that a GPS nmea sentence has the correct time? I use a module to keep a pic rtc accurate but have noticed that when...

    towlerg Today, 15:02 Go to last post