• PicŪ Basic


  • PCB Rework Equipment

    Article Preview

    This is how you can make an easy Hot Plate. Put the soldering iron away, it is way too big for those little pins and besides, ...
    Article Preview

    A thermocouple is created when certain alloys are mechanically joined with another alloy, the result is a junction that ...
    Article Preview

    For many people using these fine pitched ICs is a problem since their pin pitch has become so small you can barely see the ...
    Article Preview

    There is no easier way to place components than to use vacuum. You need low volume and low vacuum.

    Vacuum ...

    This article is not ready yet. I'm trying to find an easy way to generate pressure to use for dispensing solder.
    ...
    Article Preview

    A recent forum discussion related to PCB cleaning, carried a few posts on the various fluids that might be used. Poeple often experiment with non standard substances in an effort to find cheaper or more efficient solutions to common day probelms. PCB's are often contaminated with hard to remove substances, anything from greasy finger marks to glue from labels.
    ...
    Categories:
    1. PICŪ BASIC
    Article Preview

    by Olivier de Broqueville



    Developing often small prototypes, and hating 'proto' ...

  • Recent Activity

    kbaykar-24295

    Fault in bit wise comparisons on release 3.6.1.2.

    Thread Starter: kbaykar

    Hi Les, I just downloaded the release 3.6.1.2 today and seeing that it supports 18F47K40. I am trying to port my code from 18F4685 to 18F47K40. ...

    kbaykar Today, 17:26 Go to last post
    John Drew-26

    About Define directive...

    Thread Starter: SELCUK

    Hi Les, Thank you for new version of Proton Plus. For both Compiler version 3.6.1.1 and 3.6.1.2 If I define $DEFINE FF $0C ;// Form...

    John Drew Today, 02:10 Go to last post
    towlerg-21522

    Num_Byte on 18F26K42

    Thread Starter: towlerg

    I'm using a macro that was created by the generator Dump Macro P1 #if (Prm_Count > 1) #error "Dump - Too many parameters" #else ...

    towlerg Today, 19:20 Go to last post
    normnet-324

    Update path?

    Thread Starter: normnet

    I am currently running Proton v3.6.0.2 and would like to update to the latest version. Can i install the latest Update v3.6.1.2 on top of my...

    normnet Today, 14:41 Go to last post