Proton BASIC Compiler - PCB Rework Equipment


  • PicŪ Basic


  • PCB Rework Equipment RSS Feed

    Article Preview

    This is how you can make an easy Hot Plate. Put the soldering iron away, it is way too big for those little pins and besides, ...
    Article Preview

    A thermocouple is created when certain alloys are mechanically joined with another alloy, the result is a junction that ...
    Article Preview

    For many people using these fine pitched ICs is a problem since their pin pitch has become so small you can barely see the ...
    Article Preview

    There is no easier way to place components than to use vacuum. You need low volume and low vacuum.

    Vacuum ...

    This article is not ready yet. I'm trying to find an easy way to generate pressure to use for dispensing solder.
    ...
    Article Preview

    A recent forum discussion related to PCB cleaning, carried a few posts on the various fluids that might be used. Poeple often experiment with non standard substances in an effort to find cheaper or more efficient solutions to common day probelms. PCB's are often contaminated with hard to remove substances, anything from greasy finger marks to glue from labels.
    ...
    Categories:
    1. PICŪ BASIC
    Article Preview

    by Olivier de Broqueville



    Developing often small prototypes, and hating 'proto' ...

  • Recent Activity

    joesaliba-353

    It's Christmas, how about a bit of giving?

    Thread Starter: johngb

    How about sending some Christmas to Les as donations for all the support and continued improvements he has provided throughout the year. You can...

    joesaliba Yesterday, 13:43 Go to last post
    RobSchade-98754

    Newbie to the forum

    Thread Starter: RobSchade

    Hi everyone I'm a newbie to the forum but not to Proton Basic. I've been using ProtonIDE for about 10 years on and off. Most of the projects were...

    RobSchade Yesterday, 10:32 Go to last post
    towlerg-21522

    SERIN/SEROUT how low can you go?

    Thread Starter: davroski

    (PIC is 16F18344 on 32 MHz internal clk). I want to use SERIN/SEROUT (hardware UART already in use) at lower than 300 bd - preferably as close to...

    towlerg Yesterday, 18:41 Go to last post
    towlerg-21522

    Clean up old versions

    Thread Starter: rcurl

    I just installed 3.7.3.3 and after the install was done I had two shortcuts on my desktop. It appears I have two working versions installed at the...

    towlerg Yesterday, 13:17 Go to last post