• PicŪ Basic


  • PCB Rework Equipment

    Article Preview

    This is how you can make an easy Hot Plate. Put the soldering iron away, it is way too big for those little pins and besides, ...
    Article Preview

    A thermocouple is created when certain alloys are mechanically joined with another alloy, the result is a junction that ...
    Article Preview

    For many people using these fine pitched ICs is a problem since their pin pitch has become so small you can barely see the ...
    Article Preview

    There is no easier way to place components than to use vacuum. You need low volume and low vacuum.

    Vacuum ...

    This article is not ready yet. I'm trying to find an easy way to generate pressure to use for dispensing solder.
    ...
    Article Preview

    A recent forum discussion related to PCB cleaning, carried a few posts on the various fluids that might be used. Poeple often experiment with non standard substances in an effort to find cheaper or more efficient solutions to common day probelms. PCB's are often contaminated with hard to remove substances, anything from greasy finger marks to glue from labels.
    ...
    Categories:
    1. PICŪ BASIC
    Article Preview

    by Olivier de Broqueville



    Developing often small prototypes, and hating 'proto' ...

  • Recent Activity

    John Drew-26

    PicKit3 Programmer

    Thread Starter: Dave-S

    Trying to setup a PicKit3 Programmer. Has gone through the install programmer and the Dos screen flashes up but does not stay there, and it does not...

    John Drew Today, 00:08 Go to last post
    chuckieboy-123

    complie issue

    Thread Starter: chuckieboy

    Hi All It's been a long time since I've played with PDS. Back in 2013 I wrote a program all working correctly, I've recently was required to make an...

    chuckieboy Yesterday, 23:56 Go to last post
    towlerg-21522

    16F627 - How do I enable pull-ups on PORTB?

    Thread Starter: davroski

    Hi, Data sheet says OPTION register bit 7 (RBPU) should be set to 0 but compiler 3.5.9.9 doesn't seem to recognise OPTION.7 = 0 or RBPU = 0 Thanks...

    towlerg Today, 01:02 Go to last post
    Dave-S-350

    UMC Loader

    Thread Starter: Dave-S

    Trying to use the MicroCode loader, but when I select either Loader or Loader Options from the "View" menu it just opens my Melabs Programmer. How...

    Dave-S Yesterday, 15:23 Go to last post
  • Tag Cloud