• Pic« Basic

  • Technology

    Rittal has introduced two ranges of guide rails for PCBs which it says can be made to suit any depth of PCB insertion. ...

    Intersil is offering a synchronous buck point-of-load (POL) regulator for low-voltage ICs in rad-hard and high-reliability ...

    We all use a large number of electrical items that work reliably and safely every day. As problems are so rare many people get blasÚ about the need for electrical safety regulations, but recently I saw some sobering statistics.


    A new Picture Gallery has been added to our index - a look behind the scenes at the Witch restoration project in The National Museum of Computing at Bletchley Park.


    An Engineer in Wonderland - A 74HC74 hysteresis mystery The development 'lab' has moved to the kitchen table as the workshop is so cold that there is liquid nitrogen sloshing around on the floor. And as my 'scope, Dr Frustration appears to be in the house. For two evenings I have been trying to fault-find a breadboard circuit with only four components that is so trivial I almost didn't try it. And am not even sure I am at the bottom of it yet.


    What happened to AT&T and the venerable Bell Laboratories? I know some of you will look at this question and say - AT&T is still around, I keeping seeing ads for all sorts of AT&T stuff. Isn't it the largest cellular carrier?


    Initial debugging complete, I knocked up a pcb in the kitchen. I used CadSoft's wonderful free Eagle layout editor to design the board.


  • Recent Activity


    PicKit3 Programmer

    Thread Starter: Dave-S

    Trying to setup a PicKit3 Programmer. Has gone through the install programmer and the Dos screen flashes up but does not stay there, and it does not...

    Oldhack Today, 12:43 Go to last post

    Issue with MID$

    Thread Starter: Frizie

    Hi people! I have a small issue with the MID$ command. If I put a semi-colon in the source-string then I get the compiler error: Unbalanced...

    towlerg Today, 12:59 Go to last post

    complie issue

    Thread Starter: chuckieboy

    Hi All It's been a long time since I've played with PDS. Back in 2013 I wrote a program all working correctly, I've recently was required to make an...

    charliecoultas Today, 11:11 Go to last post

    UMC Loader

    Thread Starter: Dave-S

    Trying to use the MicroCode loader, but when I select either Loader or Loader Options from the "View" menu it just opens my Melabs Programmer. How...

    Dave-S Today, 08:20 Go to last post

    16F627 - How do I enable pull-ups on PORTB?

    Thread Starter: davroski

    Hi, Data sheet says OPTION register bit 7 (RBPU) should be set to 0 but compiler doesn't seem to recognise OPTION.7 = 0 or RBPU = 0 Thanks...

    towlerg Today, 01:02 Go to last post
  • Tag Cloud