• PicŪ Basic


  • Example Code

    Published on 17th January 2017 16:58

    A Forum User presented this question...and Les offered a solution
    I'm working with the Microchip MCP1630 LED driver board using a PIC12F683 controller, and they offer the firmware in assembler.

    How can use this assembler in Proton, so I can modify it? If I set the device type in Proton and enclose their code between Asm- and Endasm- I get quite a few different assembler errors. Am I doing something basically wrong?

    John

    ...

    Don't post here. Please choose one of the sub-categories under Example Code that best fit your article. If one of the current ...

    Here you will find snippets of working code that will help save you time. Please help add to our collection of examples by contributing code that you have written.

  • Recent Activity

    Les-15

    Num_Byte on 18F26K42

    Thread Starter: towlerg

    I'm using a macro that was created by the generator Dump Macro P1 #if (Prm_Count > 1) #error "Dump - Too many parameters" #else ...

    Les Today, 17:17 Go to last post
    John Drew-26

    Fault in bit wise comparisons on release 3.6.1.2.

    Thread Starter: kbaykar

    Hi Les, I just downloaded the release 3.6.1.2 today and seeing that it supports 18F47K40. I am trying to port my code from 18F4685 to 18F47K40. ...

    John Drew Today, 13:41 Go to last post
    SimonJA-751

    Hx711 calibration

    Thread Starter: amod

    Iam using load cell amplifier HX711 module.I have got raw values from module but iam not able to calibrate with load cell.I want make a universal...

    SimonJA Today, 07:38 Go to last post