Proton BASIC Compiler - Add New Section


  • PicŪ Basic


  • Example Code RSS Feed

    Published on 17th January 2017 17:58

    A Forum User presented this question...and Les offered a solution
    I'm working with the Microchip MCP1630 LED driver board using a PIC12F683 controller, and they offer the firmware in assembler.

    How can use this assembler in Proton, so I can modify it? If I set the device type in Proton and enclose their code between Asm- and Endasm- I get quite a few different assembler errors. Am I doing something basically wrong?

    John

    ...

    Don't post here. Please choose one of the sub-categories under Example Code that best fit your article. If one of the current ...

    Here you will find snippets of working code that will help save you time. Please help add to our collection of examples by contributing code that you have written.

  • Recent Activity

    joesaliba-353

    It's Christmas, how about a bit of giving?

    Thread Starter: johngb

    How about sending some Christmas to Les as donations for all the support and continued improvements he has provided throughout the year. You can...

    joesaliba Yesterday, 13:43 Go to last post
    RobSchade-98754

    Newbie to the forum

    Thread Starter: RobSchade

    Hi everyone I'm a newbie to the forum but not to Proton Basic. I've been using ProtonIDE for about 10 years on and off. Most of the projects were...

    RobSchade Yesterday, 10:32 Go to last post
    towlerg-21522

    SERIN/SEROUT how low can you go?

    Thread Starter: davroski

    (PIC is 16F18344 on 32 MHz internal clk). I want to use SERIN/SEROUT (hardware UART already in use) at lower than 300 bd - preferably as close to...

    towlerg Yesterday, 18:41 Go to last post
    towlerg-21522

    Clean up old versions

    Thread Starter: rcurl

    I just installed 3.7.3.3 and after the install was done I had two shortcuts on my desktop. It appears I have two working versions installed at the...

    towlerg Yesterday, 13:17 Go to last post